Page 10 - HOPPE HLS One
P. 10
Multipoint Hardware Installation - Active Panel
Active Panel Hardware Installation
1. When the door is in the open position, the bevel on the latch
Top should push the latch into the lockcase when you close the door.
Extension If you need to reverse the latch, see the instructions below.
Machine
Screw 2. Slide main gear into place, aligning holes drilled in door face with
cylinder, handle holes and lockcase to properly accommodate trim.
Latch 3. Install handle set per instructions included with the set.
4. Remove machine screw in top of lockcase.
Lockcase 5. Slide top extension into place and fasten to lockcase with the
supplied machine screws to door edge. The screws should be
screwed in flush with the faceplate, but not overtightened.
6. Test gear with the door in the open position. Engage system by
Note: Main gear and extensions should lifting handle and note if multipoint system operates on the edge
be hand-tightened only. Excessive force of the door. Extend deadbolt by turning thumbturn. If system is
may cause driverail to bind and inhibit working properly, the locking points on the edge of the door and
system operation. the deadbolt will extend smoothly and completely. If not working
properly, please refer to the Troubleshooting Guide on the website:
www.us.hoppe.com.
Reversing the Latch
1. Push small screwdriver or punch into reversing hole and push latch
up until latch clears lockcase.
2. Rotate latch 180 ° with hand and release back into lockcase.
Removing the Shipping Clip & Reversing the
Mishandling Device
1. Remove sticker covering the shipping clip.
2. Remove shipping clip so that mishandling device is visible and
extended.
3. Make sure mishandling device is sloped in the same direction as
the latch.
4. If not, pull out mishandling device with hand and rotate it 180 °.
5. Release mishandling device back into lockcase.
10