Page 16 - Strybuc Swing Door Catalog
P. 16

Profile CylinDers

                      Profile Cylinder Accessories Rekeying Instructions

         ! Rekeying should be done by a qualified locksmith.    ! When rekeying a CES cylinder using CES pins, use the CES pin
         ! Cylinder designs vary. HOPPE supplies CES brand      number that corresponds with the measured key cut.
        cylinders and non-logo cylinders.                     ! When rekeying a CES cylinder using Schlage® pins, use the
         ! Cylinders feature Schlage® SC1 keyways and may be      Schlage® pin number that is one less than the measured
        rekeyed using Schlage® rekey kits.                   key cut. A key cut measuring 4 uses a #3 Schlage® pin.
         ! Cylinders should be rekeyed to an existing Schlage® key      ! When rekeying a non-logo cylinder using CES pins, use the CES pin
        whenever possible.                                   number that is one higher than the measured key cut. A key cut measuring
         ! The HOPPE key gauge measures key cuts 1 through 9 the      4 uses a #5 CES pin.
        same as a Schlage® key gauge.                         ! When rekeying a non-logo cylinder using Schlage® pins, use the
                                                             Schlage® pin number that corresponds with the measured key cut.






       Part #  Description
     850-8773863  50mm          850-8785231           850-8750635           850-2667482           850-2426890
     850-2406936  60mm      Key Blanks - Schlage® 5-Pin  Construction Key with Cylinder   Construction Key   8mm Square Construction Key
     Stainless Steel Cylinder Screws              Gauge. Long Version (Blue)  Short Version (Black)
               Steps to Rekey CES Cylinder with Plastic Insert      Steps to Rekey HOPPE Cylinder with Set Screws
        1.                    Remove PLASTIC INSERT           1.                        Remove one SET SCREW at a
                              using REMOVAL TOOL as                                     time using 2 mm HEX
                              shown and tap out PINS                                    WRENCH as shown and tap
                              and SPRINGS                                               out PINS and SPRINGS
















     850-2000899  850-8771719   Part #      Description         850-3475773      850-8762427       850-3459001
      Removal Tool  Plastic Insert  850-8785239 Standard - 100 cylinder capacity  Set Screw  2mm Hex Wrench  30 cylinder capacity Key Kit
                              850-8785243 Mini-Kit - 10 cylinder capacity                        Contains Schlage® Pins
                                      Contains CES Pins
        2.         850-2070820

                    HOPPE Key                                        Determine CORE PIN size with KEYING GAUGE
                      Gauge

        3.     1. Insert desired CORE PIN into the appropriate    PLASTIC                             SCREWS
                                                                                                        SET
                                                              PLUG
                 cylinder pin hole.
                Note: For cylinder designs featuring six pin holes, the innermost
                hole (furthest from the key face) is left blank.  SPRINGS                             SPRINGS
               2. Insert HOUSING PIN
               3. Insert SPRING                              HOUSING                OR                HOUSING
               4. Repeat until all PINS have been replaced and    (TOP)                                 (TOP)
                 install PLASTIC INSERT OR install SET SCREW    PINS                                    PINS
                 and repeat until all PINS have been replaced.   CORE                                   CORE
                                                             (BOTTOM)                                 (BOTTOM)
                                                               PINS                                     PINS

     14                                                                                   FAX: 610-534-3202
                                                                                                          2018 PGI©
   11   12   13   14   15   16   17   18   19   20   21